Altinex Satellite Radio TP115 110 User Manual

SPECIAL APPLICATION  
MANUAL PART NUMBER: 400-0431-005  
TP115-110  
COMPUTER/COMPONENT VIDEO + AUDIO  
TWISTED PAIR TRANSMITTER  
USER’S GUIDE  
 
SPECIAL APPLICATION  
PRECAUTIONS / SAFETY WARNINGS  
1
·
This equipment has been tested and found to  
comply with the limits for a Class A digital  
device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable  
protection against harmful interference when the  
Please read this manual carefully before using your  
TP115-110. Keep this manual handy for future  
reference. These safety instructions are to ensure  
the long life of your TP115-110 and to prevent fire  
and shock hazards. Please read them carefully and  
heed all warnings.  
equipment is operated in  
a
commercial  
environment. This equipment generates, uses,  
and can radiate radio frequency energy and, if  
not installed and used in accordance with the  
instruction manual, may cause harmful  
interference to radio communications. Operation  
of this equipment in a residential area is likely to  
cause harmful interference in which case the  
user will be required to correct the interference  
at his own expense.  
1.1 GENERAL  
·
Qualified ALTINEX service personnel or their  
authorized representatives must perform all  
service.  
1.2 INSTALLATION  
·
To prevent fire or shock, do not expose this unit  
to water or moisture. Do not place the  
TP115-110 in direct sunlight, near heaters or  
heat-radiating appliances, or near any liquid.  
Exposure to direct sunlight, smoke, or steam can  
harm internal components.  
·
Any changes or modifications to the unit not  
expressly approved by ALTINEX, Inc. could void  
the user’s authority to operate the equipment.  
·
·
Handle the TP115-110 carefully. Dropping or  
jarring can damage the unit.  
Do not pull any cables that are attached to the  
TP115-110.  
1.3 CLEANING  
·
Clean only with a dry cloth. Never use strong  
detergents or solvents such as alcohol or  
thinner. Do not use a wet cloth or water to clean  
the unit. Do not open the unit to clean.  
1.4 FCC NOTICE  
·
This device complies with Part 15 of the FCC  
Rules. Operation is subject to the following two  
conditions: (1) This device may not cause  
harmful interference, and (2) this device must  
accept any interference received, including  
interference that may cause undesired  
operation.  
400-0431-005  
2
 
SPECIAL APPLICATION  
ABOUT YOUR TP115-110  
2
TECHNICAL SPECIFICATIONS  
3
Specifications are subject to change.  
See www.altinex.com for up-to-date information.  
TP115-110  
COMPUTER/COMPONENT VIDEO +  
AUDIO TO TWISTED PAIR (TP)  
TRANSMITTER  
FEATURES/  
TP115-110  
DESCRIPTION  
GENERAL  
Inputs  
The TP115-110 provides transmission of computer  
video and audio signals over Twisted Pair-type  
(CAT-5) cable when used together with an  
ALTINEX Twisted Pair receiver, such as the  
TP115-111. Stereo audio input is received via the  
3.5 mm jack and is converted to mono prior to  
transmission over the CAT-5 cable. The TP115-110  
is lightweight, streamlined, and easy to use.  
RGBHV/YPbPr  
Stereo Audio  
Output  
15-pin HD female  
3.5mm female  
Video + Audio  
Compatibility  
RJ-45 female  
ALTINEX – Twisted Pair  
Standard for TP Series  
VGA through UXGA  
Signal types  
This unit offers video equalization for up to 400 ft  
(122 m) and the signal detect feature shows when  
a signal is present.  
Signal resolutions  
or 480p, 567p, 720p, 1080i  
Table 1. TP115-110 General  
The latest generation of Twisted Pair devices uses  
an innovative, patented technology* developed by  
ALTINEX. The new signal processing technology  
allows transmitting and receiving fully equalized  
computer video signals, stereo, and audio signals  
over long distances. The maximum distance at full  
UXGA resolution is 400 ft (122 m) between devices  
and may reach up to 750 ft (230 m) at VGA  
resolution.  
MECHANICAL  
TP115-110  
Weight  
1.0 lb (0.45 kg)  
0.09” Aluminum,  
Black Semi Gloss  
4.58 in (116 mm)  
Enclosure  
Length  
Width  
3.50 in (89 mm)  
0.96 in (24 mm)  
10°C-50°C  
Height  
T° Operating  
T° Maximum  
Humidity  
MTBF (calc.)  
OPTIONS  
75°C  
A second RJ-45 connector may be added to drive  
two TP receivers, or the input connectors may be  
substituted for use with composite or S-Video  
signals.  
90% non-condensing  
38,000 hrs  
Table 2. TP115-110 Mechanical  
ELECTRICAL  
Input  
TP115-110  
Video Analog Signal  
Video Sync Level  
Audio Signal Level  
Output  
1.0 Vp-p max.  
TTL  
* US Patent 7,065,190  
0 dBu  
ALTINEX – Twisted Pair  
Standard for TP Series  
Video + Mono Audio  
Power  
9 VDC Power  
3.6 W max.  
Table 3. TP115-110 Electrical  
400-0431-005  
3
 
SPECIAL APPLICATION  
PRODUCT DESCRIPTION  
4
400-0431-005  
4
 
SPECIAL APPLICATION  
APPLICATION DIAGRAMS  
DIAGRAM 1: TYPICAL SETUP  
5
TP115-110  
TP115-111  
400-0431-005  
5
 
SPECIAL APPLICATION  
DIAGRAM 2: INTERNAL VIEW  
SIGNAL  
DETECT  
POWER  
SYNC  
PROCESSING  
HOR  
H/W  
EQ  
VER  
COMPUTER/  
COMPONENT  
PAIR 1  
PAIR 3  
PAIR 2  
VIDEO  
RED  
15-PIN HD  
BLUE  
GREEN  
TWISTED  
PAIR  
OUTPUT  
PLUG AND PLAY  
LEFT  
AUDIO  
STEREO  
3.5mm  
PAIR 4  
RIGHT  
9V, 1A  
2.5mm  
PS  
400-0431-005  
6
 
SPECIAL APPLICATION  
INSTALLING YOUR TP115-110  
6
OPERATION  
7
Step 1. Determine the best location for the  
TP115-110 and TP115-111. Where  
possible, locate the TP115-110 as close  
to the video source as possible and the  
TP115-111 as close to the receiving  
component as feasible.  
The TP115-110 requires only one adjustment be  
made for optimal performance. The adjustment is  
video equalization for long cable lengths.  
7.1 VIDEO EQUALIZATION  
Video equalization is provided to fine-tune the  
displayed image on the remote display.  
Typically, the equalization will be set to near  
minimum for short cable runs. Cable lengths up  
to 400 ft (122 m) will require near maximum  
equalization.  
Step 2. Apply power to the TP115-110 using the  
power adaptor provided. The Power LED  
should be on and red.  
Step 3. Connect the video source to the input of  
the TP115-110 using a high-quality video  
cable.  
The equalization adjustment on the TP115-110  
works together with the TP115-111 to provide  
equalization for maximum cable lengths. For  
example, for cable runs less than 50 ft (15 m),  
both equalization settings may be set to near  
minimum. Cable runs of 400 ft (122 m) will see  
equalization settings at about the three-quarter  
position.  
Step 4. The Power LED should change from red  
to green indicating a signal is present.  
Step 5. Connect the audio input source to the  
audio jack on the TP115-110.  
Step 6. Run  
a
CAT-5  
cable  
from  
the  
4TP OUTPUT of the TP115-110 to the  
4TP INPUT on the TP115-111.  
TROUBLESHOOTING GUIDE  
8
We have carefully tested and have found no  
problems in the supplied TP115-110. However, we  
would like to offer suggestions for the following:  
NOTE: Ensure good signal transmission  
by routing the cable avoiding any  
sharp angles, creases, or bends.  
8.1 NO DISPLAY  
Step 7. Connect the TP115-111 video and audio  
outputs to their receiving devices.  
Cause 1: The source has a problem.  
NOTE: The L+, L- and GND outputs on  
the TP115-111 terminal block  
output contain the mono audio  
output signal. The R+ and R-  
pins are not used.  
Solution: Check the source and make sure  
there is a signal present and all  
source connections are correct. If  
the source is working and there is  
still no display, see Cause 2.  
Step 8. Apply power to the TP115-111 using the  
power adaptor provided. The Power LED  
should be on and red; green if a signal is  
present.  
Cause 2: The path has a problem.  
Solution: Connect the transmitter directly to  
the receiver using a short CAT-5  
patch cable. If the image is good,  
there is a problem with the cable.  
Otherwise, see Cause 3.  
Step 9. The units are now operational.  
Cause 3: Cable connections are incorrect.  
Solution: Make sure the cables are properly  
connected. Also, make sure that the  
continuity and wiring are good. If  
there is still no display present, see  
Cause 4.  
400-0431-005  
7
 
SPECIAL APPLICATION  
Cause 4: Video equalization required.  
ALTINEX POLICIES  
9
Solution: Adjust the VIDEO EQUALIZATION  
on the TP115-110. Long cable runs  
may require adjustment on both the  
TP115-110 and TP115-111.  
9.1 LIMITED WARRANTY/RETURN POLICIES  
Please see the ALTINEX website at  
www.altinex.com for details on warranty and  
return policies.  
In general, cable runs less then 50 ft  
(15 m) require little or no video  
equalization and should be set to  
minimum. Cable runs up to 400 ft  
(122 m) will require near maximum  
equalization on both the transmitter  
and receiver.  
9.2 CONTACT INFORMATION  
ALTINEX, Inc.  
592 Apollo Street  
Brea, CA 92821 USA  
TEL: 714 990-2300  
Cause 5: The display has a problem.  
TOLL FREE: 1-800-ALTINEX  
Solution: Make sure the display is powered  
and is turned on. If there is still no  
display, please call ALTINEX at  
(714) 990-2300.  
8.2 NO SOUND  
Cause 1: The source has a problem.  
Solution: Check the source and make sure  
that there is a signal present and all  
source connections are correct. If  
the source is working and there is  
still no sound, see Cause 2.  
Cause 2: The volume is too low.  
Solution: Increase the gain at the source  
toward maximum. If there is still no  
sound present, see Cause 3.  
Cause 3: Cable connections are incorrect.  
Solution: Make sure that cables are properly  
connected. Also, make sure that the  
continuity and wiring are good. If  
there is still no sound, see Cause 4.  
Cause 4: The receiving device has  
problem.  
a
Solution: Make sure the receiving device is  
powered and is turned on. If there is  
still no sound, please call ALTINEX  
at (714) 990-2300.  
400-0431-005  
8
 

AKG Acoustics Microphone SPC 4 User Manual
Alamo Lawn Mower TS 100A TS 115A TS 125A TS 135A User Manual
Alto Shaam Microwave Oven 714ES User Manual
Amana Air Conditioner RCB18C2CP1247513C User Manual
American Audio Music Mixer CommanderPlus User Manual
Aspire Digital Computer Hardware M1610 User Manual
Atmel Computer Accessories AT91EB42 User Manual
AVerMedia Technologies DVD Player EB5416DVD User Manual
Axis Communications Printer NPS 530 User Manual
Axxess Interface Automobile Parts OESWC LAN29 STK User Manual