Baby Trend Stroller 7581 User Manual

Read all instructions BEFORE assembly and USE of product.  
KEEP INSTRUCTIONS FOR FUTURE USE.  
Model #7581  
Sit N Stand Plus  
with Car Seat Snap N Go Attachment System  
US PATENT #5,664,795  
Instruction Manual  
Convenience through innovation and thoughtful design  
06.06  
 
PARTS  
Parent Tray  
Front Wheels  
Child Tray  
Snap N Go Attachment  
Bar  
Rear Wheels  
Foot Rest  
Stroller  
Front/Rear Canopies  
ASSEMBLING  
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE  
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE  
ASSEMBLY  
1. Remove stroller from box. The front wheels, rear wheels, child tray, and  
canopies need to be installed prior to use.  
Fig. 1.  
2. To attach the front wheels, unfold stroller as described in the section  
following. See figure 1. Lean the stroller backwards so that it rests on  
the handle and rear frame tubes and the front wheel tubes are pointing  
upward. Position the front wheel assembly at the front tube such that  
the large hole in the swivel assembly will slide onto the front tube. Push  
each front wheel assembly onto the front tube being careful that wheel  
assembly locks onto the front leg. Pull on the wheel assembly to ensure  
that it is securely attached to the stroller. Please see figure 2.  
3. Lean the stroller forward to rest on the front wheels. To attach the rear  
wheels, position the rear axle and wheel assembly such that the brake  
levers are facing to the rear of the stroller. Press the rear wheel assembly  
onto the rear frame tubes being careful that the push buttons on the  
forward side of each rear tube engage the hole on the forward side of  
each rear wheel housing. Pull on the rear wheel assembly to ensure that  
it is securely attached to the stroller. Please see figure 3.  
4. Ensure that the wheels are firmly locked into place. Do Not use the  
stroller if the wheels are not locked into place, but rather contact our  
customer service department immediately at (800) 328-7363, between  
the hours of 8:00am and 4:30pm PCT, for assistance.  
5. Snap footrest onto front legs of stroller just below the seat. Push  
downward on the footrest until it locks onto the rivets protruding from  
both sides of each leg and snaps onto the U-shaped frame cross member.  
Please see figure 4.  
Fig. 2.  
Fig. 3.  
Fig. 4.  
Snap On  
Push  
Down  
3
 
6. To attach the front child tray, push the tray onto the front frame tube,  
lining up the tray between the protruding rivets. Push backward on the  
latch until snapped into place. The protruding rivets on the outside of  
the frame tube should be between the tray latch. Check that the tray is  
securely latched in place. Please see figure 5 and 6.  
Fig. 5.  
7. To remove front child tray, pull outward on the latches and pull outward  
on the tray. Please see figure 7. Please note that you may attach or  
remove one end at a time.  
Rivet  
WARNING: The child’s tray is not a  
restraint device: always secure your child with  
the seat belt. DO NOT lift the stroller by the  
child’s tray. Use care when attaching the child’s  
tray on the stroller with a child in the stroller.  
Fig. 6.  
8. To attach the front canopy, line up the male fittings on the canopy with  
the female fittings on the armrest and push both fittings downward until  
snapped into place. Please see figure 8. Push forward on the front edge  
of the canopy to open.  
9. To attach the rear canopy line up the female fittings of the canopy with  
the male fittings on the handle frame tube and push downward. Please  
see figure 9.  
Fig. 7.  
10. To remove rear canopy reverse installation steps and pull up to remove.  
Please see figure 9A.  
11. To remove front canopy depress the plastic attachment and pull upward  
to remove. Please see figure 9B.  
Fig. 8.  
Fig. 9.  
Fig. 9A.  
Fig. 9B.  
4
 
WARNING: Avoid serious injury from  
falling or sliding out. Always use the seat belt.  
TO SECURE CHILD  
Fig. 10.  
TO SECURE FRONT/REAR SITTING CHILDREN  
1 The shoulder straps of the 5-point harness has 2 attachment positions.  
Select the loop position that places the shoulder strap level with, or below  
the top of the child’s shoulder and feed the shoulder harness under the  
correct loop. Please see figure 10.  
Shoulder Strap  
2. Carefully place the child in the stroller seat and bring the safety harness  
around the child’s waist and over the shoulders. Place the crotch strap  
and between the child’s legs. Insert the male end of each shoulder / waist  
belt into the buckle on the crotch strap. Tighten the harness to be snug  
around the child’s waist and over the child’s shoulders. Please see figure  
11.  
Waist  
Strap  
Squeeze  
3. To release, apply pressure to both sides of each male clip until the clip  
is released. This process requires a moderate amount of effort so as to  
prevent an accidental release by your child. NOTE: Buckles may be hard  
to release when 1st used.  
Adjust for a  
snug fit  
Crotch Strap  
Fig. 11.  
TO SECURE REAR STANDING CHILD  
1. The rear platform and jump seat are designed to accommodate a child  
who is at least 2 1/2 years old, has good balance and coordination, and is  
not over 40 inches tall. Position the child on the platform on the back of  
the stroller. Be sure child is facing forward and hands are holding frame.  
Secure the safety belt behind child and engage buckle. See figure 12.  
2. Be sure that the child’s feet are fully on the platform at all times.  
PLEASE NOTE: When using the rear SEAT you must put the STAND  
FEATURE SAFETY BELT in the storage location located on the rear of  
the seat. Please See Fig. 12A  
Fig. 12.  
WARNING: To avoid a possible  
choking hazzard when using the rear seat, put  
the STAND FEATURE SAFETY BELT in the  
storage location on the rear of the seat.I  
TO USE JUMP SEAT  
Fig. 12A.  
1. Have child sit on the jump seat facing backwards. Secure the seat belt,  
which is attached to the back of the seat, around the child’s waist, and  
buckle to the crotch strap. See figure 12B. Adjust the seat belt to be snug  
around the child’s waist.  
2. To release, apply pressure to both sides of the male clip until the clip  
is released. This process requires a moderate amount of effort so as to  
prevent an accidental release by your child.  
3. Be sure that the child’s feet are fully on the platform at all times.  
Fig. 12B.  
5
 
TO RECLINE SEATS  
SEATBACK POSITIONING  
1. The front seat has a two position recline. To recline the seat, rotate the  
recline bar and press backward on the seat back. Please see figure 13. To  
place the seat in the upright position, press upward on the seat back while  
rotating the recline bar.  
2. The upright position should be used only for a child that is at least 6  
months old. Note: Seat does not fully recline.  
Fig. 13.  
3. To recline the rear seat locate the plastic adjuster and squeeze the ends.  
Loosen or tighten the strap to your desired recline position. Please see  
figure 14.  
TO REMOVE REAR SEAT  
1. Remove the rear canopy. Locate the rear seat attachment positions.  
Please see figure 15. Unhook the fabric from the tabs on the stroller  
handle frame. Repeat for opposite side. Also un snap the footrest fabric  
as shown in figure 15A. To completely remove rear seat fabric you  
must unhook the D-Ring from the rear jump seat, and you must remove  
the 2 D-Rings from the rear seat. Please See Figures 15B and 15C.  
2. To remove the lower portion of the rear seat fabric, locate the two  
attachment positions. Please See Figure 16. Unhook the fabric from  
the tab on the lower frame tube, next release the front snap located on  
the same lower frame tube.  
Fig.14.  
3. When you are not using the jump seat harness place it in the storage  
location on the rear of the front seat. Please See Figure 16A.  
Fig.15.  
Fig.15.A  
Fig.16.  
Fig.15.B  
Fig.16A.  
Fig.15.C  
6
 
BRAKES  
WARNING: Always set brakes when  
the stroller is not being pushed so that the  
stroller will not roll away. Never leave stroller  
unattended on a hill or incline as the stroller  
Fig. 17.  
Fig. 18.  
may slide down the hill.  
1. To engage brakes, apply light downward pressure to the brake lever located  
on each rear wheel. The stroller may require slight forward or rearward  
movement in order to line up the teeth on the brake with each wheel brake  
cluster. See figure 17. Check that the stroller will not move and that the  
brakes are properly applied. To release, gently lift up on the brake lever.  
See figure 18.  
CANOPIES  
Fig. 19.  
1. To open the canopies, push forward on the front frame of the canopies.  
To close canopies, pull the front edge toward the rear of the stroller until  
folded. Always fold the canopies prior to folding the stroller frame. Please  
see figure 19.  
2. The canopies will ratchet forward or back to block the sun. Pull forward  
on the front canopy frame tube to move forward. Pull backward on the  
rear frame tube to move back.  
TO REMOVE FRONT CHILD TRAY  
Fig. 20.  
1. To remove front child tray, pull forward on the locking lever on the tray  
arms to unlock. Please see figure 7. Please note that you may attach or  
remove one end at a time. Also, the tray may be released on either side  
and will swing away for easy access to your child.  
Fold Button  
TO FOLD STROLLER  
Do Not allow children near stroller while folding.  
1. Close the canopies as described in the Canopies section above. Ratchet  
the front canopy all the way back. Please see figure 20.  
Release Button  
Fig. 21.  
2. Unbuckle rear standing safety belt. Please see figure 12.  
3. To fold the stroller slide the red fold latch safety button in the center of the  
handle and squeeze the red handle while pushing forward on the handle.  
Once the stroller begins to fold, release the red handle and pull upward on  
the child tray until the stroller is folded. Please see figure 21.  
4. Secure the stroller in the folded position by latching the fold latch, located  
on the right side of the stroller handle, over the extended rivet on the  
armrest. You may have to rotate the front wheels to fold the stroller  
completely. Please see figure 22.  
Fig. 22.  
TO UNFOLD STROLLER  
7
 
TO UNFOLD STROLLER  
Do Not allow children near stroller while unfolding.  
1. Release the folding latch, which is located on the right side. See figure  
22.  
2. Lift up on the stroller handle with both hands until the stroller frame is  
erect and locked in the open position. The stroller has spring-loaded  
latches on both sides of the frame. Test that both latches are fully engaged  
prior to placing your child in the stroller.  
WARNING: Avoid serious injury from  
falling, Do Not use the Snap N Go bar if it is not  
securely locked onto both sides of the stroller.  
TO ATTACH AN INFANT CAR SEAT  
Fig. 23.  
1. Recline the front seat back. Remove the child tray.  
2. Slide snap n go attachment bar into the female slots located on the  
frame tube. Make sure the snap n go attachment bar locks in place  
before attaching the car seat. See figure 23.  
3. Place car seat onto front bar. See figure 24. NOTE: Most brands  
of infant car seats will lock onto the front bar, and some brands  
may simply rest on the front bar, FOR SAFE OPERATION, IT  
IS VERY IMPORTANT THAT THE CAR SEAT STRAP IS  
ALWAYS TIGHTLY FASTENED AROUND THE CAR SEAT.  
4. Strap the safety belt over the car seat and through the seat belt slots  
on your car seat, connect the buckles together. Tighten the strap so  
the car seat fits snug and can't move. See figure 24. Check that the  
car seat is secure before using the stroller.  
Fig. 24.  
STOP  
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT, PLEASE  
CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT (800) 328-7363 BETWEEN  
THE HOURS OF 8:00AM AND 4:30PM PACIFIC COAST TIME FOR ASSISTANCE.  
8
 

ADTRAN Switch 1224R User Manual
Aga Ranges Range F107411 01 User Manual
Aiwa CD Player XR M131 User Manual
Aiwa Stereo System CX NA31 User Manual
Alvin Mobility Aid CH555 User Manual
American DJ DJ Equipment Colorwash 4 User Manual
ATMT MP3 Player MP130 User Manual
Axis Communications Security Camera AXIS T95A00 User Manual
Azden Microphone 411DRH User Manual
Behringer Music Pedal DI600P User Manual